Figure 142: Machine Type; Figure 143: Select Specific Machine - Jamesway Sentry Manual

Choose the type of machine to
which the profile is to be sent
by moving the cursor to the
appropriate line using the "UP"
and "DOWN" arrow keys.
Select 'Specific Machine' to
choose to which machine the
profile should be sent.
Selecting 'Specific Machine'
will present the screen shown
in the next step, else the screen
shown in Figure 144 will be
displayed. Selecting 'Abort' or
pressing "EXIT" will return to
the editing screen without
saving changes.
NOTE: Even though it is possible to retrieve a profile from one machine type and then store it at a
machine of a different type, the operator should be aware that the profiles may not be compatible. For
example the 'ACI Hatcher' type needs a damper position setting, but the 'Hatcher' type does not.
This screen is shown only if
'Specific Machine' was chosen
in the previous step. Use the
arrow keys to highlight the
machine to which the profile
should be sent. Press
"ENTER" to continue to the
next step, or "EXIT" to abort
and return to the profile editing
screen.
80 Sentry Control System

Figure 142: Machine Type

Figure 143: Select Specific Machine