Figure 71: Password Entry; Figure 72: Machine List - Jamesway Sentry Manual

If password security is
enabled, the operator is
requested to enter the
password after selecting the
desired group of machines. An
incorrect password denies
entrance to the 'Change
Calibration' screen.
The operator is prompted to
select the machine that needs
to be calibrated. The cursor
can be moved one machine at a
time using the arrow keys, or
moved a full screen using the
"PAGE UP/DOWN" keys. The
"HOME" and "END" keys
move the cursor to the
corresponding point in the
machine list. When the desired
machine is highlighted, press
"ENTER" to adjust the
machine offsets.
NOTE: If the display's
humidity option setting is not
the same as the type of humidity sensor on the machine, an error message will be displayed, since no
humidity unit conversion can be used for calibration. If an error message occurs, simply change the
display's humidity option as described on page 95, and then retry this operation. With version 1.22 or
later, humidity can be calibrated in RH or wet bulb. Conversion errors may occur if the sensor reads RH
and the machine is calibrated in wet bulb.
44 Sentry Control System

Figure 71: Password Entry

Figure 72: Machine List