NEC Xen Master Programming Manual page 73

Programming Manual
Automatic Day/Night Mode
Switching Time Assignment
General Description
Use this Memory Block to assign Pattern 1 and Pattern 2 start times for automatically
switching between Day Mode and Night Mode.
Display
Data Pattern
No. (1/2)
2 7 : 1
T I M E
Programming Procedures
1 Go off-line.
BG
2 Press LK1 + LK1 +
3 Enter the data using the dial pad.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K I
~ to enter numeric data
U
to clear all data when the cursor is in the Data No. position
N
4 Press to write the data. The switching time for pattern 2 is displayed.
5 Use the dial pad to change the time.
N
6 Press to write the data.
P
7 Press to go back on-line.
Related Programming
M.B. Number
1-1-32
Automatic Day/Night Mode by Day of Week Selection
1-4-05
Automatic Tandem Trunk by Night Mode Selection
1-8-07
Class of Service (Attendant) Feature Selection 1
4-07 Code Restriction Class Assignment (Day Mode)
4-08
Code Restriction Class Assignment (Night Mode)
4-09
Telephone to Tenant Assignment
4-17
Station to Class of Service Feature Assignment
4-37
Extension Line Key Ring Assignment (Day Mode)
4-38 Extension Line Key Ring Assignment (Night Mode)
Automatic Day/Night Mode Switching Time Assignment
Day Mode Night Mode
Start Time Start Time
Setting Data Setting Data
: , :
D I S P L A Y
to access the Memory Block.
Memory Block Name
May 2003
System Mode
1
Submode
1
Data No.
27
PC Programming
a
+BM
Default Values
Not Specified
1-1-27
1 - 55