NEC Xen Master Programming Manual page 54

NEC Business Solutions Ltd
CO/PBX Incoming Ringing Alarm
Time Selection
General Description
Use this Memory Block to specify the time interval between the time a CO/PBX call is
detected and the time the ringing tone changes to a higher pitch when the call is not
answered. If No Limit is selected, the ringing tone does not change.
Display
Data
No.
0 6 : R I N G
T I M E
Settings
LK 1 LK 2
10 sec. 20 sec.
LK 5 LK 6
Programming Procedures
1 Go off-line.
KF
2 Press LK1 + LK1 +
3 Press the corresponding CO/PBX line key to change the data option.
N
4 Press to write the data.
P
5 Press to go back on-line.
Related Programming
M.B. Number
1-1-07 Tie Line Delay Ringing Timer Selection
3-07
CO/PBX Ringing Variation Selection
4-01
CO/PBX Ring Assignment (Day Mode)
4-02 CO/PBX Ring Assignment (Night Mode)
4-62 Telephone Ringing Variation Selection
N
1. Memory Blocks 4-01 CO/PBX Ring Assignment (Day Mode) and 4-02 CO/PBX Ring Assignment (Night Mode) must
be set to ring.
2. CO/PBX lines assigned for DIT/ANA do not activate this feature.
3. Tie/DID lines assigned for Delayed Ringing follow this assignment after the delayed ringing starts.
4. This feature uses the same ringing tone (Low, Medium, High) that can be selected in Memory Blocks 3-07 CO/PBX
Ringing Variation Selection and 4-62 Telephone Ringing Variation Selection. If High is selected in those Memory
Blocks, this feature does not function.
5. Select No Limit (∞) to disable this feature.
1 - 36
Setting
Title Data
∞
A L M
D I S P L A Y
LK 3 LK 4
∞
30 sec.
The shaded area indicates the default setting.
LK 7 LK 8
to access the Memory Block.
Memory Block Name
CO/PBX Incoming Ringing Alarm Time Selection
Xen Master & Xen Axis
1-1-06
System Mode
1
Submode
1
Data No.
06
PC Programming
a
+BM