NEC Xen Master Programming Manual page 127

Programming Manual
Caller ID Display Assignment for
System Mode
General Description
Use this Memory Block to assign up to 15 Multiline Terminals to display Caller ID Indication
for normal incoming CO/PBX calls or CO/PBX calls ringing a Call Arrival (CAR) key.
Display
Data
No.
7 8 : C A L L I D
T I M E
Programming Procedures
1 Go off-line.
2 Press LK1 + LK1 + GH
3 Use the dial pad to enter Entry No.1 or 2 and Tel Port No.
Note: Use the following to enter data:
J
to move the cursor left
L to move the cursor right
K I
~ to enter numeric data
N
4 Press to write the data and advance to the next Entry No. After data for Entry No. 2 is entered, press
15 entries can be made.
P
5 Press to go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
1. To display Caller ID Indication for normal incoming and CAR incoming calls, Caller ID Indication and Ring Assignment
must be assigned for the terminal in system programming.
2. Fifteen Multiline Terminals can be assigned system-wide to display Caller ID.
3. A sixteenth terminal can be assigned to display Caller ID using another Memory Block.
Caller ID Display Assignment for System Mode
Entry Tel Port No.
Title No. (00~99 A0~A9
1~7 1~15 B0~B9 CO)
1 = 0 0
D I S P L A Y
to access the Memory Block.
System Mode
Submode
Data No.
PC Programming
a
Default Values
Not specified
N
May 2003
1-1-78
1
1
78
+AI
again. A total of
1 - 109