NEC Xen Master Programming Manual page 404

NEC Business Solutions Ltd
Internal Zone Paging Selection
General Description
Use this Memory Block to place stations in Internal page zones.
Display
Tel Port No.
(01~99)
Data
A0~C0
No.
0 1 / 9 3 : Z O N E
T I M E
Settings
LK 1 LK 2
No Zone A
LK 5 LK 6
Programming Procedures
1 Go off-line.
2 Press LK4 + IC to access the Memory Block.
3 Press the corresponding CO/PBX line key to change data option.
Note: Use the following to change option:
R
select next Tel Port No.
N
4 Press to write the data.
P
5 Press to go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
1. Specify one zone:
All Internal Zones: Paged by dialling 51
Zone A:
Zone B:
Zone C:
2. Telephones can be assigned to NO Zone. All Internal Zones page the telephone unless No Page Receive is assigned
in Memory Block 4-31 Receiving Internal/All Call Page Selection.
3. All Internal Zones pages all of the idle Multiline Terminals.
4. Telephone ports A0~C0 are ports 100~120.
1 - 386
Setting
Title
Data
N O
D I S P L A Y
LK 3 LK 4
Zone B Zone C
The shaded area indicates the default setting.
LK 7 LK 8
Paged by dialling 52
Paged by dialling 53
Paged by dialling 54.
Xen Master & Xen Axis
4-93
System Mode
4
Submode
—
Data No.
93
PC Programming
a
+BTM
Internal Zone Paging Selection