NEC Xen Master Programming Manual page 426

NEC Business Solutions Ltd
Telephone Type Assignment
General Description
Use this Memory Block to specify the type of device that is connected to an ESI port.
Display
ESI
Port No.
(01~96)
0 1 : T E L
T I M E
Settings
LK 1 LK 2
DSS Con-
Non Telephone
LK 5 LK 6
Voice Mail
Programming Procedures
1 Go off-line.
2 Press LK7 + LK2 to access the Memory Block.
3 To change data, press the corresponding CO/PBX line key.
Note: Use the following to enter data:
R
: Next Tel Port No.
N
4 Press to write the data.
P
5 Press to go back on-line.
Related Programming
M.B. Number
Refer to Chapter 2 Guide to Feature Programming.
N
1. Only Multiline Terminals can be assigned to ports 01 and 02.
2. A maximum of four Attendant Add-On Consoles can be installed in the system.
3. A maximum of eight SLT(1)-U13 ADP adapters can be installed in the system.
4. A maximum of eight Digital Voice Mail ports are available.
5. When assigning SLT adapters or Digital Voice Mail ports, Memory Block 4-10 Station Number Assignment must be
reassigned also.
6. If more than one DSS console is assigned, make sure that the order of assignment is as follows:
DSS1 must always be a lower port than DSS2
DSS2 must be a lower port than DSS 3
DSS3 must be a lower port than DSS 4
1 - 408
Setting Data
D I S P L A Y
LK 3 LK 4
SLT
sole Adapter
The shaded area indicates the default setting.
LK 7 LK 8
Digital
Memory Block Name
Xen Master & Xen Axis
7-2
System Mode
7
Telephone
2
Data No.
—
PC Programming
a
+BS
Telephone Type Assignment