NEC Xen Master Programming Manual page 407

Programming Manual
Digit Add/Del for Tie Line
Networking
General Description
Use this Memory Block to specify the number of digits to be added to and/or deleted from
the telephone number sent from a distant system over Tie lines or from DID lines. The digits
enable the system to determine whether a call is directed to itself (local) or to another
system (distant). Refer to the Notes.
Display
Trunk
Group
Data
No.(01~32)
No.
0 1 / 0 0 : A D D / D E L 0 0 0
T I M E
Programming Procedures
1 Go off-line.
N
2 Press LK5 + + KK
3 Press the corresponding CO/PBX line key to enter the data.
Note: Use the following to enter data:
J
to move the cursor left
L to move the cursor right
K I
~ to enter numeric data
R
to go to the next Trunk Group No.
Setting Data:
000 : No Addition or Deletion
001~009 : [1]~[9] Addition
010 : [0] Digit Addition
100~199 : [00]~[99} Addition
201 : 1 Digit Deletion
202 : 2 Digit Deletion
301~309 : 1 digit Delete and 1~9 Add
310 : 1 digit Delete and 0 Add
400~499 : 1 digit Delete and 00~99 Add
501~509 : 2 digit Delete and 1 ~ 9 Add
510 : 2 digit Delete and 0 Add
600~699 : 2 digit Delete and 00 ~99 Add
4 After entering all data for all pages, press
P
5 Press to go back on-line.
Digit Add/Del for Tie Line Networking
Setting
Title Data
D I S P L A Y
to access the Memory Block.
N
to write the data.
May 2003
5-00
System Mode
5
Submode
—
Data No.
00
PC Programming
a
+ALN
1 - 389