NEC Xen Master Programming Manual page 181

Programming Manual
Automated Attendant Delay
Announcement Hold Tone Selection
General Description
Use this Memory Block to specify the tone that is sent to the outside party after the
Automated Attendant Delay Announcements are played.
Display
Data
No.
1 7 : A A
T I M E
Settings
LK 1 LK 2
RBT MOH
LK 5 LK 6
Programming Procedures
1 Go off-line.
A G
2 Press LK1 + LK4 +
3 Press the corresponding CO/PBX line to change data option.
Example: To change RBT to MOH, press CO/PBX line key 2.
N
4 Press to write the data and advance to Memory Block 1-4-18 Automated Attendant Delay Announcement Assignment
P
5 Press to go back on-line.
Related Programming
M.B. Number
1-4-18
Automated Attendant Delay Announcement Assignment
Automated Attendant 1 st to 2 nd Delay Announcement Interval Time Selection
1-4-19
1-4-20
Automated Attendant Delay Announcement Disconnect Time Selection
Automated Attendant Delay Announcement Hold Tone Selection
Setting
Title
H O L D R B T
D I S P L A Y
LK 3 LK 4
The shaded area indicates the default setting.
LK 7 LK 8
to access the Memory Block.
Data
Memory Block Name
May 2003
System Mode
1
Submode
4
Data No.
17
PC Programming
a
+AU
Default Values
All Messages One Time
1-4-17
1 - 163