Programming Manual
DIT Night Mode Delay Answer
Enable
General Description
This Memory Block is used to specify whether or not the DIT Delay Answer Timer shall
apply to CO/PBX calls received when the system is in Night Mode.
Display
CO/PBX
No.
Data
(01~64)
No.
1 1 / 6 4 :
T I M E
Settings
LK 1
LK 2
No
Yes
LK 5
LK 6
Programming Procedures
1 Go off-line.
N
2 Press LK3 +
+
3 Press the corresponding CO/PBX line key to change the data option.
Note:
Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
R
to go to the next CO/PBX Line No.
N
4 Press
to write the data.
P
5 Press
to go back on-line.
Related Programming
M.B. Number
3-61
DIT Delay Answer Timer Selection
N
1. The DIT Delay Answer Time specified in MB 3-61 shall apply for this purpose.
2. If set to YES, incoming CO/PBX calls during Night Mode will ring for the duration specified in MB 3-61 before
changing to DIT status.
3. If set to NO, incoming CO/PBX calls during Night Mode will immediately change to DIT status regardless of the setting
in MB 3-45.
4. This setting only applies to those CO/PBX lines assigned with the DIT facility in MB 3-42 and MB 3-43.
DIT Night Mode Delay Answer Enable
Setting
Title
Data
N T M O D
N 0
D I S P L A Y
LK 3
LK 4
The shaded area indicates the default setting.
LK 7
LK 8
DD
to access the Memory Block.
Memory Block Name
May 2003
3-64
System Mode
3
Submode
—
Data No.
64
PC Programming
a
+BCT
1 - 311