NEC Xen Master Programming Manual page 34

NEC Business Solutions Ltd
LK 1 System Mode
LK 4 Transfer/Automated Attendant (A.A.) (Continued)
Data
Memory Block Name
No.
15 Automated Attendant Message Access
Code (2-Digit) Assignment
16 Automated Attendant Message Repeat
Selection
17 Automated Attendant Delay
Announcement Hold Tone Selection
18 Automated Attendant Delay
Announcement Assignment
19
Automated Attendant 1
Delay Announcement Interval Time
Selection
20 Automated Attendant Delay
Announcement Disconnect Time
Selection
21 Automated Attendant Extension
Number Assignment
22 Automated Attendant Direct Extension
Ring or Ring Assignment
LK 1 System Mode
LK 5 SMDR/LCR
Data
Memory Block Name
No.
02 SMDR Print Format
13 Printer Connected Selection
14 Outgoing Mode Selection
25 SMDR Valid Call Timer Assignment
26 SMDR Incoming/Outgoing Print
Selection
1 - 16
Default Value
Refer to Automated Attendant Message Access Code (2-Digit)
Assignment on page 1-161.
All Messages One Time
RBT
Not specified
4 minutes
st nd
to 2
30 seconds
Not Specified
Not Specified
Default Value
All
No
No
00 = 0 sec.
All
Xen Master & Xen Axis
Programming Values
1, 2, 3, 4, 5, 6, 7, 8 times
RBT (Ringback)
MOH (Music on Hold)
None, MSG 1, MSG 2, MSG 3, MSG 4,
MSG 5, MSG 6, MSG 7, MSG 8
0 sec., 10 sec., 20 sec., 30 sec., 1 min.,
2 min., 3 min., 4 min., 5 min., 10 min.,
20 min.
0 sec., 10 sec., 20 sec., 30 sec., 1 min.,
2 min., 3 min., 4 min., 5 min., 10 min.,
20 min.
Tel No. (Up to 4 digits) phantom number
only (for each AA message 1~8)
Tel No. (Up to 4 digits) real extension
number or CAR (for each AA message
1~8)
Programming Values
All, Mask Digits
No, PC, Printer
Yes, No
00~99 sec. (input value) x 10 sec.
All, Outgoing, Incoming
Multiline Terminal Programming