NEC Xen Master Programming Manual page 68

NEC Business Solutions Ltd
DID Digit Conversion Table & DNIS
Assignment
General Description
Up to 200 incoming DID numbers can be assigned individually to ring at preassigned
extension numbers on a day mode and night mode basis. This Memory Block applies to the
DID number after it is modified by Memory Block 5-00.
Display
Data Digits
No. Received
2 2 :
DNIS ASSIGNMENT
Settings
LK 1 LK 2
TENANT=TN
TEL=T
(v2.xx or higher)
LK 5 LK 6
Note: Version 1.xx and 2.xx shows the time in DNIS assignment area.
Programming Procedures
1 Go off-line.
2 Press LK1 + LK1 + BB
3 Enter the data using the dial pad.
Note: Use the following to enter data:
J to move the cursor left
L
to move the cursor right
K I to enter numeric data
~
S
to change DNIS, then use
each indial number (name applies to both day and night mode). Refer to Table 1-
7, "System Data Input," on page 444 for details on character entry.
Q
to change between Day and Night table
U
to clear all data
N
4 Press to write the data.
P
5 Press to go back on-line.
1 - 50
Title Destination
D Y = T
LK 3 LK 4
The shaded area indicates the default setting.
LK 7 LK 8
to access the Memory Block.
K I to enter an alphanumeric name for
~
Xen Master & Xen Axis
PC Programming
Default Values
Setting Data
TEL = LK1 = Extension No.00~99
000~999
0000~9999
TENANT = LK2 = 00~47
DID Digit Conversion Table & DNIS Assignment
1-1-22
System Mode
1
Submode
1
Data No.
22
a
+ALN