NEC Xen Master Programming Manual page 281

Programming Manual
Trunk Name/Number Assignment
General Description
Use this Memory Block to specify telephone name/number for the CO/PBX lines
accommodated so that the information is displayed when the CO/PBX Line is seized, or
during an incoming call.
Display
CO/PBX No.
(01~64)
0 1 / 9 7 2 - 7 5 1 - 7 0 0 0
T I M E
Settings
LK 1 LK 2
Number Name
LK 5 LK 6
Programming Procedures
1 Go off-line.
2 Press LK3 + KK to access the Memory Block.
3 Use the dial pad to enter data.
Note: Use the following enter data:
J to moves the cursor left
L
to moves the cursor right
K ~ I to numeric keys for entering data
Q
to generate a - (hyphen)
U
to generate a s
R
to go to the next CO/PBX Line No.
N
4 Press to write the data.
P
5 Press to go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
When a name is selected, use Section 7 Character Code Tables on page 1-442 to get the character codes.
Trunk Name/Number Assignment
Setting Data
(13 digits maximum)
D I S P L A Y
LK 3 LK 4
There is no default setting.
LK 7 LK 8
pace (clear after hold)
May 2003
System Mode
3
Submode
—
Data No.
00
PC Programming
a
+BCT
Default Values
Not Specified
3-00
1 - 263