NEC Xen Master Programming Manual page 140

NEC Business Solutions Ltd
Customised Message 1~10
Assignment
General Description
Use this Memory Block to program various messages for display at a station LCD. When a
user places an intercom (ICM) call from a station equipped with an LCD display to a station
in DND mode, the appropriate programmed message displays at the calling station.
Display
Data
No.
0 9 : D O N ' T D I S T U R B
T I M E
Programming Procedures
1 Go off-line.
2 Press LK1 + LK2 + KI
3 Enter the options using the dial pad.
Note: Use the following enter data:
J to move the cursor left
L
to move the cursor right
K ~ I to enter numeric data
U
to clear data
4 Enter the characters to be displayed. Refer to Section 7, Character Code Tables.
5 After entering all data for Memory Block 1-2-09~18 Customised Message 1~10 Assignment, press
P
6 Press to go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
Ten messages are available, the first six are assigned at default.
1 - 122
Setting Data
(13 Digits max.)
D I S P L A Y
~
AH to access the Memory Block.
Default Values
Data No. Message
09 DON'T DISTURB
10 MEETING
11 BUSINESS TRIP
12 NOT IN
13 WITH GUEST
14 OUT OF OFFICE
~
Not Specified
15 18
N
Customised Message 1~10 Assignment
Xen Master & Xen Axis
1-2-09~18
System Mode
1
Submode
2
Data No.
09~18
PC Programming
a
+BI
to write the data.