NEC Xen Master Programming Manual page 405

Programming Manual
3-Minute Alarm Selection
General Description
Use this Memory Block to specify, per station, whether or not a warning signal tone is
generated at 3-minute intervals during an outgoing or incoming CO/PBX call.
Display
Tel Port No.
(01~99)
Data
A0~C0
No.
0 1 / 9 4 : 3 m A L M
T I M E
Settings
LK 1 LK 2
No Ys
LK 5 LK 6
Programming Procedures
1 Go off-line.
ID
2 Press LK4 + to access the Memory Block.
3 Press the corresponding CO/PBX line key to change data option.
Note: Use the following to change option:
R
select next Tel Port No.
N
4 Press to write the data.
P
5 Press to go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
1. A 1-second (approximately) warning signal sounds every 3 minutes during CO/PBX calls.
2. The alarm tone is heard through the terminal speaker only.
3. If the built-in speakerphone is used for Handsfree, the warning signal is not used.
4. Telephone ports A0~C0 are ports 100~120.
3-Minute Alarm Selection
Setting
Title Data
N O
D I S P L A Y
LK 3 LK 4
The shaded area indicates the default setting.
LK 7 LK 8
May 2003
4-94
System Mode
4
Submode
—
Data No.
94
PC Programming
a
+BTM
1 - 387