NEC Xen Master Programming Manual page 70

NEC Business Solutions Ltd
DID Forward Station Number for
Undefined Digit
General Description
This Memory Block is used when Memory Block 1-1-21 DID Digit Conversion Assignment is
enabled. Undefined Digits are classified as in-dial numbers not listed in Memory Block 1-1-
22 DID Digit Conversion Table & DNIS Assignment.
Display
Data
No.
2 3 : T R F
T I M E
Settings
LK 1 LK 2
NON TEL
LK 5 LK 6
Programming Procedures
1 Go off-line.
2 Press LK1 + LK1 + BC
3 Enter the data using the dial pad.
Note: Use the following to enter data:
J to move the cursor left
L
to move the cursor right
K I
~ to enter numeric data
Q
to insert a pause
U
to clear all data
N
4 Press to write the data.
P
5 Press to go back on-line.
Related Programming
M.B. Number
1-1-22
DID Digit Conversion Table & DNIS Assignment
N
1. MB 1-1-23 DID Forward Station Number for Undefined Digit is only used when MB 1-1-21 DID Digit Conversion
Assignment is enabled (e.g. set to 'Y').
2. Call Forward Busy, Station Hunting or Call Alert Notification should be used to accommodate direct indial calls to
busy stations.
1 - 52
Setting
Title Data
E X T = N O N
D I S P L A Y
LK 3 LK 4
TENANT
The shaded area indicates the default setting.
LK 7 LK 8
to access the Memory Block.
Memory Block Name
DID Forward Station Number for Undefined Digit
Xen Master & Xen Axis
System Mode
1
Submode
1
Data No.
23
PC Programming
a
+ALN
Default Values
NON
Setting Data
Tel = Extension No.
00~99
000~999
0000~9999
TN = Tenant No. 00~47
1-1-23