NEC Xen Master Programming Manual page 445

Timer
Tie line Answer
Detect Time Selection
Tie Line Release
Detect Time Selection
Tie Line/CO/PBX
Incoming Signal
Detect Time Selection
Tie Line Loop Off-
Guard Time Selection
Tie Line Length of
Wink Signal Selection
Tie Line Length of
Delay Signal
Selection
Tie Line Incoming
Interdigit Timeout
Selection
Tie Line Wink/Delay
Signal Detect Timeout
Selection
Disconnect
Recognition Time
Selection
DIT Delay Answer
Timer Selection
*Software Version 2.xx or higher
Programming Manual
Table 1-6 Function Timer Chart (Continued)
Memory
Definition
Block
3-17 Specify the duration between the
time when the receiving system
answers and the time when it is
recognized as an answer.
3-18 Specify the duration between the
circuit disconnection detection on
the Tie line on the distant system
side and the time it is recognized
as Tie Line Release.
3-19 Specify the time between the
detection of an incoming signal
from another Xen system and the
time when the acknowledgment
signal is sent (Expressed as Wink
Start/Delay/COI in ms.).
3-20 Assign loop off-guard protection to
prevent noise that may cause the
system to be unable to answer an
incoming Tie line.
3-21 Specify the time between the
incoming signal detection from
another Xen system and when the
acknowledgment signal is sent out.
3-22 Specify the time a delay pulse is
sent to another system.
3-24 Specify the maximum time during
the incoming call detection
process. If an address signal is not
received within a specified time, an
error tone is returned to the other
system.
3-25 Specify the maximum time for
receiving an acknowledgment
signal from a distant system before
sending a busy tone.
3-33 Specify a minimum time for a
disconnected circuit to be
accessed again.
3-61 This Memory Block is used to
specify the time and incoming CO/
PBX call will ring before changing
to DIT.
Timing Value
Minimum Default
0 ms. 520 ms.
0 ms. 520 ms.
0/0/5 520/120/200
0 sec. 2 sec.
30 ms. 180 ms.
0 ms. 300 ms.
1 sec. 6 sec.
1 sec. 7 sec.
0 sec. 0.3 sec
0 sec. 5 sec.
May 2003
Maximum
1950 ms.
1950 ms.
1950/450/
800
13 sec.
480 ms.
4500 ms.
No Limit
No Limit
1.5 sec.
60 sec.
1 - 427