NEC Xen Master Programming Manual page 166

NEC Business Solutions Ltd
Automated Attendant First Digit
PBR Release Timer Selection
General Description
Use this Memory Block to specify the time a Push Button Receiver (PBR) circuit remains
connected after the Automated Attendant message is played when a calling party calls in
through an Automated Attendant trunk.
Display
Data
No.
0 1 : A A
T I M E
Settings
LK 1 LK 2
5 sec. 10 sec.
LK 5 LK 6
40 sec. 50 sec.
Programming Procedures
1 Go off-line.
KA
2 Press LK1 + LK4 +
3 Press the corresponding CO/PBX line key to change the data option.
N
4 Press to write the data.
P
5 Press to go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
After PBR is connected, dialling must be completed in the specified time. After the first digit is dialled, interdigit timing
(default 7 sec.) controls the PBR timer. Dialing the third digit exceeds the 20 sec. default, and the PBR is disconnected.
1 - 148
Setting
Title Data
P B R T I M E 2 0 s
D I S P L A Y
LK 3 LK 4
20 sec. 30 sec.
The shaded area indicates the default setting.
LK 7 LK 8
60 sec.
to access the Memory Block.
Automated Attendant First Digit PBR Release Timer Selection
Xen Master & Xen Axis
1-4-01
System Mode
1
Submode
4
Data No.
01
PC Programming
a
+AU