NEC Xen Master Programming Manual page 115

Programming Manual
Code Restriction Class Allow/Deny
Selection
General Description
Use this Memory Block to assign Code Restriction Classes 01~14 as Allow or Deny. This
assignment is used when there is no match or there is an overlap (duplicate numbers in
tables with opposite assignments) of numbers in the 8-Digit Matching Tables.
Display
Data
No. Title
6 5 : C L A S S
T I M E
Settings
LK 1 LK 2
Allow (YS) Deny (NO)
LK 5 LK 6
Programming Procedures
1 Go off-line.
2 Press LK1 + LK1 + FE
3 Press the corresponding CO/PBX line key to change data option.
N
4 Press to write the data and advance to the next class. Repeat steps 3 and 4 until last class is assigned.
N
5 Press to write selected data.
P
6 Press to go back on-line.
Related Programming
M.B. Number
Refer to Section 6 Code Restriction in this chapter.
N
1. If a match is not found or duplicate match is made with opposite assignments, the system uses this Memory Block.
2. If the interdigit dialling time duration exceeds 10 seconds while a restricted station user is dialling on an outside line,
the system automatically drops the call.
3. If phones are required to dial emergency "only", then class 01 can be used.
4. Use Memory Block 1-1-70 as the default class assignment for features such as station outgoing lockout In/Out (from
DSS console and password lockout.
Code Restriction Class Allow/Deny Selection
Class
No.
01~14 Function
( 0 1 ) = Y S
D I S P L A Y
LK 3 LK 4
The shaded area indicates the default setting.
LK 7 LK 8
to access the Memory Block.
Default Values
Class 01
Class 02~14
Memory Block Name
May 2003
1-1-65
System Mode
1
Submode
1
Data No.
65
PC Programming
a
+AC
Deny (NO)
Allow (YES)
1 - 97