NEC Xen Master Programming Manual page 371

Programming Manual
Trunk Digit Restriction
General Description
Use this Memory Block to specify the maximum number of digits per station that can be
dialled while on any outside line.
Display
Tel Port No.
(01~99)
Data
A0~C0
No.
0 1 / 3 2 : D G
T I M E
Programming Procedures
1 Go off-line.
2 Press LK4 + CB to access the Memory Block.
3 Use the dial pad to enter Setting Data (00 ~ 99 digits).
Note: Use the following to enter data:
K I
~ to enter numeric data
R
to select next Tel Port No.
N
4 Press to write the data.
P
5 Press to go back on-line.
Related Programming
M.B. Number
Refer to Section 6 Code Restriction in this chapter.
N
1. Code Restriction must be assigned before this feature is used.
2. Trunk Digit Restriction applies to all CO/PBX lines.
3. Tie Line Code Restriction must be assigned before this feature works on Tie lines.
4. Telephone ports A0~C0 are ports 100~120.
Trunk Digit Restriction
Setting
Title Data
R E S T = 0 0
D I S P L A Y
Default Values
00 (No Limit)
Memory Block Name
May 2003
4-32
System Mode
4
Submode
—
Data No.
32
PC Programming
a
+BTT
1 - 353