NEC Xen Master Programming Manual page 301

Programming Manual
Tie Line Incoming Interdigit
Timeout Selection
General Description
Use this Memory Block to specify a time interval during the incoming call detection process
so that if an address signal is not received within a specified time, an error tone is returned
to the other system.
Display
CO/PBX
No.
Data
(01~64)
No.
0 1 / 2 4 :
T I M E
(Page 1)
LK 1 LK 2
No Limit 1 sec.
LK 5 LK 6
4 sec. 5 sec.
(Page 2)
LK 1 LK 2
8 sec. 9 sec.
LK 5 LK 6
12 sec. 13 sec.
Programming Procedures
1 Go off-line.
N
2 Press LK3 + +
3 Press the corresponding CO/PBX line key to change the data option.
Note: Use the following enter data:
S
to go to the next page
T
to go to the previous page
R
to go to the next CO/PBX Line No.
N
4 Press to write the data.
P
5 Press to go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
1. A timeout occurs when:
A dial pulse is not received within the time specified by this Memory Block after the receiving side detects the
off-hook signal.
The next dial pulse is not received within the time specified by this Memory Block after the receiving side
detects (receives) a dial pulse.
2. This Memory Block affects T1 channels assigned to Tie/DID lines.
Tie Line Incoming Interdigit Timeout Selection
Page
Setting
No.
Title Data
I N C O M 6 s | 1
D I S P L A Y
LK 3
2 sec.
LK 7
6 sec.
LK 3
10 sec.
LK 7
14 sec.
BD to access the Memory Block.
LK 4
3 sec.
LK 8
7 sec.
The shaded area indicates the default setting.
LK 4
11 sec.
LK 8
15 sec.
May 2003
3-24
System Mode
3
Submode
—
Data No.
24
PC Programming
a
+ALM
1 - 283