NEC Xen Master Programming Manual page 15

S 1
ECTION
A
BOUT THIS MANUAL
S 2
ECTION
M
ANUAL
O
RGANIZATION
S 3
ECTION
S
UPPORTING
D
OCUMENTS
Programming Manual
Preface
The Programming Manual was developed primarily for the technician and
provides all necessary information for programming the Xen Master and
Axis systems.
Programming can be accomplished using either a PC or a Multiline
Terminal.
This manual provides instructions for programming the Xen system.
Chapter 1 – Multiline Terminal Programming
This chapter includes all of the Memory Blocks used to program the system.
Detailed programming instructions are provided for each Memory Block.
Chapter 2 – Guide to Feature Programming
This chapter includes a list by feature of the Memory Blocks necessary for
programming each feature.
Chapter 3 – PC Programming
This chapter includes the instruction or programming using Xen PC
software.
The Xen system has a set of manuals that provide all the information
necessary to install and support the system. The remaining manuals which
comprise the set are described below.
Features and Specifications Manual
This manual provides detailed information related to every feature available
in the system.
General Description Manual
This manual provides general information about the system, its features,
system configuration and standards. This manual provides an overview of
the Xen system and is useful when presenting information to potential
customers.
System Hardware Manual
The System Hardware Manual is provided for the system installer. This
manual provides detailed instructions for installing the Xen KSU, ETUs,
Multiline Terminals, and optional equipment.
xv