NEC Xen Master Programming Manual page 337

Programming Manual
Trunk Type Selection
General Description
This Memory Block specifies each external line as CO line, PBX/CTX line, Tie/DID line, or
CTX Assume - 9.
Display
CO/PBX
No. Data
(01~64) No.
0 1 / 9 1 : C O
T I M E
Settings
LK 1 LK 2
CO PBX/CTX
LK 5 LK 6
CTX Assume - 9
Programming Procedures
1 Go off-line.
N
2 Press LK3 + +
3 Press the corresponding CO/PBX line key to change the data option.
Note: Use the following to enter data:
J
to move the cursor left
L to move the cursor right
R
to go to the next CO/PBX Line No.
N
4 Press to write the data.
P
5 Press to go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
1. This Memory Block affects T1 channels assigned as Tie/DID lines.
2. Integrated Services Digital Network (ISDN) lines can be assigned as PBX/CTX or CTX Assume-9. A CTX Transfer
will not work on ISDN lines.
3. This Memory Block specifies if ISDN lines are to be DID or normal CO ring.
Trunk Type Selection
Title
D I S P L A Y
LK 3
Tie
LK 7
IA to access the Memory Block.
LK 4
DID
The shaded area indicates the default setting.
LK 8
May 2003
3-91
System Mode
3
Submode
—
Data No.
91
PC Programming
a
+BCT
1 - 319