NEC Xen Master Programming Manual page 315

Programming Manual
Automated Attendant Message to
Trunk Selection
General Description
Use this Memory Block to assign the Automated Attendant Message per-CO/PBX Trunk.
When the Automated Attendant Message is assigned to each CO/PBX Trunk, the system
automatically answers the incoming call and sends an Automated Attendant Message to
the calling party.
Display
CO/PBX
No. Data
(01~64) No.
0 1 / 3 8 : A A
T I M E
Programming Procedures
1 Go off-line.
N
2 Press LK3 + + CH
3 Enter data using the dial pad.
Setting Data:
1~8 Automated Attendant Message 1~8
Note: Use the following to enter data:
R
: Next CO/PBX Line No.
N
4 Press to write the data.
P
5 Press to go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
The attendant telephone position must dial an Access Code to activate this feature.
Automated Attendant Message to Trunk Selection
Setting
Title Data
M S G = 1
D I S P L A Y
to access the Memory Block.
System Mode
Submode
Data No.
PC Programming
a
Default Values
Message 1
May 2003
3-38
3
—
38
+AU
1 - 297