NEC Xen Master Programming Manual page 131

Programming Manual
CO Feature Code Service for
Code Restriction
General Description
Use this Memory Block to define an allowed code in the code restriction and is sent to the
CO in front of the dialled number when a CO call is made.
Display
Code
Data
Table
No.
01~10
8 2 : 0 1 =
T I M E
Programming Procedures
1 Go off-line.
2 Press LK1 + LK1 + HB
3 Use the dial pad to enter the CO No.
Note: Use the following to enter data:
J
to move the cursor left
L to move the cursor right
K ~ I to enter numeric data
N
4 Press to write the data.
P
5 Press to go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
CO Feature Code Service for Code Restriction
Setting Data
D I S P L A Y
to access the Memory Block.
Default Values
Not specified
May 2003
1-1-82
System Mode
1
Submode
1
Data No.
82
PC Programming
a
+AC
1 - 113