NEC Xen Master Programming Manual page 379

Programming Manual
LCR Class Selection
General Description
Use this Memory Block to specify, per station, the Least Cost Routing (LCR) Class. The
Xen Master/Axis system has four Area Code Tables. Each LCR Class can have different
Trunk Group access to allow priority levels for the station user.
Display
Tel Port No.
(01~99)
Data
A0~C0
No.
0 1 / 4 0 : L C R
T I M E
Settings
LK 1 LK 2
Class 0 Class 1
LK 5 LK 6
Class 4
Programming Procedures
1 Go off-line.
2 Press LK4 + DK to access the Memory Block.
3 Press the corresponding CO/PBX line key to change data option.
Note: Use the following to change option:
R
to select next Tel Port No.
N
4 Press to write the data.
P
5 Press to go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
1. LCR Class Selection corresponds to Area Code Tables as follows:
Class 0
Class 1
Class 2
Class 3
Class 3
2. Stations cannot be assigned to multiple LCR Classes.
3. An MIFM PAL must be installed in the system to support this feature.
4. Telephone ports A0~C0 are ports 100~120.
5. Access Code must always be used in order to access LCR Trunk Group 1.
LCR Class Selection
Setting
Title
Data
C L S = 0
D I S P L A Y
LK 3 LK 4
Class 2 Class 3
The shaded area indicates the default setting.
LK 7 LK 8
No LCR
Use Area Code Table 1
Use Area Code Table 2
Use Area Code Table 3
Use Area Code Table 3
May 2003
4-40
System Mode
4
Submode
—
Data No.
40
PC Programming
a
+BTT
1 - 361