NEC Xen Master Programming Manual page 284

NEC Business Solutions Ltd
Trunk-to-Trunk Transfer Yes/No
Selection
General Description
This Memory Block specifies whether or not to allow Trunk-to-Trunk Transfer.
Display
CO/PBX
No.
(01~64)
0 1 / 0 4 : T R F
T I M E
Settings
LK 1 LK 2
No Yes
LK 5 LK 6
Programming Procedures
1 Go off-line.
N
2 Press LK3 + +
3 Press the corresponding CO/PBX line key to change the data option.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data
R
to go to the next CO/PBX Line No.
N
4 Press to write the data.
P
5 Press to go back on-line.
Related Programming
M.B. Number
1-8-07 Class of Service (Attendant) Feature Selection 1
1-8-08
Class of Service (Station) Feature Selection 2
3-05
Trunk Incoming Answer Mode Selection
3-06
Automatic Tandem Trunk Assignment
5-01 Tie Line Networking Tandem Connection Assignment
N
Assign Yes to connect both trunks via Trunk-to-Trunk Transfer or Automatic Trunk-to-Trunk Transfer feature.
1 - 266
Setting
Title
Data
Y S
D I S P L A Y
LK 3 LK 4
The shaded area indicates the default setting.
LK 7 LK 8
KD
to access the Memory Block.
Memory Block Name
Trunk-to-Trunk Transfer Yes/No Selection
Xen Master & Xen Axis
3-04
System Mode
3
Submode
—
Data No.
04
PC Programming
a
+BCT