NEC Xen Master Programming Manual page 47

Programming Manual
Pause Time Selection
General Description
A pause can be inserted between digits dialled on CO/PBX and Tie lines. Use this Memory
Block to specify the length of the pause.
Display
Data
No. Title
0 0 : P A U S E
T I M E
Settings
LK 1 LK 2
1 sec. 3 sec.
LK 5 LK 6
Programming Procedures
1 Go off-line.
2 Press LK1 + LK1 + KK
3 Press the corresponding CO/PBX line key to change the data option.
N
4 Press to write the data.
P
5 Press to go back on-line.
Related Programming
M.B. Number
1-1-09
Manual Pause Selection
1-1-24 PBX/CTX Access Code Assignment I
1-1-25
PBX/CTX Access Code Assignment II
3-90
Trunk Type Selection
N
1. A pause is automatically inserted following a behind CO/PBX Access Code (e.g., 9) by programming CO/PBX lines
as PBX in Memory Block 3-90 Trunk Type Selection and 1-1-24/ 1-1-25 (PBX/CTX Access Code Assignments I/II).
2. Manual pauses can be stored for use when dialling outside lines by the Last Number Redial or Save/Store and
Repeat features when Memory Block 1-1-09 Manual Pause Selection, is programmed.
3. Pauses can be stored as part of System and Station Speed Dial buffers when needed.
Pause Time Selection
Setting
Data
3 . 0 s
D I S P L A Y
LK 3 LK 4
The shaded area indicates the default setting.
LK 7 LK 8
to access the Memory Block.
Memory Block Name
May 2003
1-1-00
System Mode
1
Submode
1
Data No.
00
PC Programming
a
+BCM
1 - 29