NEC Xen Master Programming Manual page 261

Programming Manual
ACR Feature Allow/Deny Selection
General Description
Use this Memory Block to specify whether or not ACR is system wide.
This feature requires System Software V3.XX or higher.
Display
Data
No. Title
0 0 : A C R
T I M E
Settings
LK 1 LK 2
NO YES
(Allow)
(Deny)
LK 5 LK 6
Programming Procedures
1 Go off-line.
2 Press LK1 + LK14 to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the Setting Data option.
N
4 Press to write the data.
P
5 Press to go back on-line.
Related Programming
M.B. Number
3-03 Trunk-to-Trunk Group Assignment
4-41 LCR Class Selection
1-8-08
Class of Service (Station) Feature Selection 2
1-14-01
ACR Dialling Assignment
1-14-01
ACR Dialled Number Dial Allow/Deny Selection
1-14-03 ACR Trunk Group to Route Number Assignment
1-14-05
ACR Digit Add Assignment
1-14-02
ACR Route Table Number Assignment
1-14-04
ACR Digit Delete Assignment
*When ACR is set to Allow in this MB, LCR stored on the MIF-L will stop functioning.
ACR Feature Allow/Deny Selection
Setting
Data
N O
D I S P L A Y
LK 3 LK 4
The shaded selection is the default.
LK 7 LK 8
Memory Block Name
May 2003
1-14-00
System Mode
1
Submode
14
Data No.
00
PC Programming
a
+AO
1 - 243