NEC Xen Master Programming Manual page 385

Programming Manual
ISDN Directory Number Selection
General Description
This Memory Block specifies whether or not the directory Number is presented to the
Network when a call is placed from the programmed station.
Display
Tel Port No. Data
(01~CO) No.
0 1 / 4 7 : C – I D
T I M E
Settings
LK 1 LK 2
Yes No
LK 5 LK 6
Programming Procedures
1 Go off-line.
DG
2 Press LK4 + to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the Setting Data option.
N
4 Press to write the data and display the next Memory Block.
5 Program the next Memory Block or press
Related Programming
M.B. Number
3-52
ISDN Trunk Directory Number Assignment
3-90
Trunk Type Selection
4-62
ISDN Extension-based Caller ID Assignment
N
1. When this Memory Block is set to No, and ISDN is used in CO Mode in Memory Block 3-90, the programmed number
in Memory Block 3-52 is not presented as Caller ID. The Network presents Restricted for the Caller ID information.
2. When this Memory Block is set to YES and ISDN is used in CO Mode in Memory Block 3-90, the programmed
number in Memory Block 3-52 is presented as Caller ID. The Network presents the programmed number as
Caller ID.
3. When this Memory Block is set to No and ISDN is used in DID Mode in Memory block 3-90, the programmed number
in Memory Block 3-52 is not presented as Caller ID. System Software version 5.0 or higher is required.
4. When this Memory Block is set to YES and ISDN is used in DID Mode in Memory Block 3-90, the programmed
number in Memory Block 4-62 is presented as Caller ID. The Network presents the programmed number as Caller
ID. System Software version 5.0 or higher is required.
ISDN Directory Number Selection
Setting
Title Data
Y E S
D I S P L A Y
LK 3 LK 4
The shaded area indicates the default setting.
LK 7 LK 8
P
to go back on-line.
Memory Block Name
May 2003
4-47
System Mode
4
Submode
—
Data No.
47
PC Programming
a
+AN
1 - 367