NEC Xen Master Programming Manual page 169

Programming Manual
Automated Attendant No Answer
Disconnect Time Selection
General Description
Use this Memory Block to establish how long the Automated Attendant rings a station
before automatically disconnecting the caller.
Display
Data
No.
0 3 : A A
T I M E
Settings
LK 1 LK 2
1 min. 2 min.
LK 5 LK 6
Programming Procedures
1 Go off-line.
2 Press LK1 + LK4 + KC
3 Press the corresponding CO/PBX line key to change the data option.
N
4 Press to write the data.
P
5 Press to go back on-line.
Related Programming
M.B. Number
Refer to Chapter 2 Guide to Feature Programming
3-39
Automatic Release Selection
N
If the called party does not answer in the predetermined time, the call is dropped.
1. If Busy Tone Detector is enabled in Memory Block 3-39, then disconnection of an abandoned call during an
Automated Attendant message will be performed by the Trunk Card.
2. If Busy Tone Detector is not enabled, then Abandoned Call will continue to ring in the system for the duration of the
time set in Memory Block 1-4-03.
Automated Attendant No Answer Disconnect Time Selection
Setting
Title Data
D I S 2 m
D I S P L A Y
LK 3 LK 4
3 min. 4 min.
The shaded area indicates the default setting.
LK 7 LK 8
to access the Memory Block.
Memory Block Name
May 2003
1-4-03
System Mode
1
Submode
4
Data No.
03
PC Programming
a
+ AU
1 - 151