NEC Xen Master Programming Manual page 398

NEC Business Solutions Ltd
ISDN Extension-based Caller ID
Assignment
General Description
This Memory Block provides the station DID Number (CPN, Calling Party Number) to the
Network when placing outgoing calls.
System Software version 5.0 or higher is required.
Display
Tel Port No. Data
(01~CO) No.
0 1 / 6 2 :
T I M E
Programming Procedures
1 Go off-line.
2 Press LK4 + FB to access the Memory Block.
3 Use the following to enter data:
J to move the cursor left.
L to move the cursor right.
K ~ I to enter numeric data.
– OR –
R
Press to go to the next TEL port number.
U
Press to clear data.
N
4 Press to write the data and display Memory Block 4-01.
5 Program Memory Block 4-01 or press
Related Programming
M.B. Number
3-52 ISDN Trunk Directory Number Assignment
3-90 Trunk Type Selection
4-47 ISDN Directory Number Selection
N
1. A maximum of 13 digits is allowed.
2. Hyphens/dashes are not allowed when entering the directory number.
3. This Memory Block supports only trunks assigned as DID in Memory Block 3-90.
4. When using CO Line Mode, Memory Block 3-52 is used to assign the directory number of ISDN.
1 - 380
Setting
Data
D I S P L A Y
P
to go back on-line.
Memory Block Name
ISDN Extension-based Caller ID Assignment
Xen Master & Xen Axis
4-62
System Mode
4
Submode
—
Data No.
62
PC Programming
a
+BTT