NEC Xen Master Programming Manual page 186

NEC Business Solutions Ltd
Automated Attendant Direct
Extension Ring or Ring Assignment
General Description
Use this Memory Block to ring at an extension or normal ringing after the AA PBR
timer expires
Display
Data
No. Title
2 2 : A A T R F 1
T I M E
Programming Procedures
1 Go off-line.
2 Press LK1 + LK4 + AC
3 Use the dial pad to enter data.
Note: Use the following to enter data:
J to move the cursor LEFT
J
to move the cursor RIGHT
K ~ I to enter numeric data
U
Press to clear data at cursor.
Setting data:
KK ~ II
KKK III
~
KKKK
(Depends what length the extension number has been assigned in HB1-2-03.)
N
4 Press to write the data, and advance to the next A.A.No.
5 After the last entry, press
P
6 Press to go back on-line.
Related Programming
M.B. Number
Refer to Chapter 2 Guide to Feature Programming
N
1. If extension number is not assigned, then the system follows the assignment of MB 1-4-08 (release or becomes a
normal call).
2. The extension number can be physical, CAR or AA message.
3. This memory block is applicable to main software release 4.0 and above.
1 - 168
A.A. Msg.
No.
Setting
1~8
Data
=
D I S P L A Y
to access the Memory Block.
,
~ IIII
N
to write the data.
Memory Block Name
Automated Attendant Direct Extension Ring or Ring Assignment
Xen Master & Xen Axis
System Mode
1
Submode
4
Data No.
22
PC Programming
a
+AU
Default Values
Not assigned.
1-4-22