NEC Xen Master Programming Manual page 357

Programming Manual
Station to Class of Service Feature
Assignment
General Description
Use this Memory Block to specify, per station, a class for each Table (1 and 2) to enable/
disable features.
Display
Tel Port
No.
Data
(01~99)
No.
A0~C0
0 1 / 1 7 : C L S ( 1 )
T I M E
Programming Procedures
1 Go off-line.
2 Press LK4 + AG
3 Use the dial pad to enter Service Class (00 ~ 15) for Table 1.
Note: Use the following to enter data:
J
to move the cursor left
L to move the cursor right
K I
~ for entering data
N
4 Press to write the data and display Table 2 data.
5 Enter Table 2 Service Class, and press
P
6 Press to go back on-line.
Related Programming
M.B. Number
1-8-07 Class of Service (Attendant) Feature Selection 1
1-8-08 Class of Service (Station) Feature Selection 2
N
1. Table 1 includes features that telephone ports 01 and 02 users are normally allowed to activate. Select any Class
pattern specified in Memory Block 1-8-07 Class of Service (Attendant) Feature Selection 1.
2. Table 2 includes features that all telephones users are normally allowed to activate. Select any Class pattern
specified in Memory Block 1-8-08 Class of Service (Station) Feature Selection 2.
3. Telephone ports A0~C0 are ports 100~120.
Station to Class of Service Feature Assignment
Table No. Setting Service
Title 1/2 Class
= 0 0
D I S P L A Y
to access the Memory Block.
N
again.
Default Values
Tel. No.
01
02
03 ~ C0
Memory Block Name
May 2003
4-17
System Mode
4
Submode
—
Data No.
17
PC Programming
a
+BTT
Table No. Svc. Class
1 ATTN 00
2 STA 00
1 ATTN 00
2 STA 00
1 ATTN 15
2 STA 00
1 - 339