NEC Xen Master Programming Manual page 437

Programming Manual
Second Initialisation
General Description
Use this Memory Block to initialize all the system hardware. All system software and user
programming are retained after the Second Initialization.
Display
C P U R E S E T
T I M E
Programming Procedures
1 Go off-line.
2 Press LK8 + LK8 + HHKK
3 When the system display prompt indicates CPU RESET?, the first four CO/PBX lines light red.
WWWW
Red Red Red
N
4 Press to begin the initialization process.
P
5 Press to go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
Note: IMPORTANT
If VMS, FMS, ACD and/or IPT cards installed in the system, please ensure all cards have
completed their startup sequence before performing a second initialisation.
These cards are considered fully 'started up' about 5 minutes after power is applied.
Second Initialisation
?
D I S P L A Y
to access the Memory Block.
Red
May 2003
8-8-8800
System Mode
8
CO-Line
8
Data No.
8800
PC Programming
a
+CI
1 - 419