NEC Xen Master Programming Manual page 419

Programming Manual
Trunk Group Mode Copy
Assignment
General Description
Use this Memory Block to enable copying data from one Trunk Group to another Trunk
Group or multiple consecutive Trunk Groups.
Display
Title
T R K G P
T I M E
Programming Procedures
1 Go off-line.
2 Press LK6 + to access the Memory Block.
LK5
3 Enter the Trunk Group to be copied.
Note: Use the following to enter data:
K ~ I to enter numeric data
U
to clear all data when placed at cursor position
Related Programming
No related programming is necessary for this Memory Block.
To copy data of Trunk Group 01 to Trunk Groups 10~14:
Example:
1. Enter the original Trunk Group using the dial pad; press 01~32.
Title
T R K
T I M E
N
2. Press .
— — T R K
T I M E
3. Enter the Start Trunk Group No. (01~32). Using the dial pad, press
— — T R K
T I M E
Trunk Group Mode Copy Assignment
Setting
Data
— —
D I S P L A Y
Setting
Data
G P 0 1 — —
D I S P L A Y
Setting
Title
Data
G P —
D I S P L A Y
Setting
Title Data
G P 1 0 —
D I S P L A Y
AK .
May 2003
6-5
System Mode
6
Trunk Group
5
Data No.
—
1 - 401