NEC Xen Master Programming Manual page 165

Programming Manual
Tandem Transfer Automatic
Disconnect Timer Selection
General Description
Use this Memory Block to specify maximum time before the system automatically
disconnects a Trunk-to-Trunk connection.
Display
Data
No.
0 0 : A U T O
T I M E
Settings
LK 1 LK 2
30 min. 1 hr.
LK 5 LK 6
Programming Procedures
1 Go off-line.
2 Press LK1 + LK4 + KK
3 Press the corresponding CO/PBX line key to change the data
option or enter the time required in minutes
N
4 Press to write the data.
P
5 Press to go back on-line.
Related Programming
M.B. Number
Refer to Chapter 2 Guide to Feature Programming
N
This block is used for Direct Inward System Access (DISA), Trunk-to-Trunk Transfer, Call Forward - Off Premise, and Tie
line tandem features.
Tandem Transfer Automatic Disconnect Timer Selection
Setting
Title Data
D I S 0 6 0
D I S P L A Y
LK 3 LK 4
2 hr. 3 hr.
The shaded area indicates the default setting.
LK 7 LK 8
to access the Memory Block.
Default Values
060 min
Setting Data
000~999 (Software Version 2.xx or later)
Memory Block Name
May 2003
1-4-00
System Mode
1
Submode
4
Data No.
00
PC Programming
a
+AT
1 - 147