NEC Xen Master Programming Manual page 297

Programming Manual
Programming Procedures
1 Go off-line.
N
2 Press LK3 + +
3 Press the corresponding CO/PBX line key to change the data option.
Receiving Side
Note: Use the following to enter data:
S
to go to the next page
T
to go to the previous page
R
to go to the next CO/PBX Line No.
N
4 Press to write the data.
P
5 Press to go back on-line.
Related Programming
M.B. Number
3-14
Tie/DID Line Type Assignment
N
1. For the second dial tone method and the immediate method, the time is fixed at 30 ms.
Tie Line/CO/PBX Incoming Signal Detect Time Selection
AI to access the Memory Block.
Incoming Signal Detection
Sending Acknowledgment Signal
Time
Memory Block Name
May 2003
DC Loop Supervision
1 - 279