NEC Xen Master Programming Manual page 269

Programming Manual
ACR Digit Delete Assignment
General Description
Use this Memory Block to specify the number of digits to be deleted from the Route
assignment.
This feature requires System Software S3.XX or higher.
Display
Data
No.
0 5 : D E L E T E
T I M E
Programming Procedures
1 Go off-line.
L
2 Press LK1 + LK14 +
K
3 Use dial pad keys
J
Note: Use to move cursor left.
L
Use to move cursor right.
If setting data is 00, digits are not deleted.
N
4 Press to write the data.
P
5 Press to go back on-line.
Related Programming
M.B. Number
3-03
Trunk-to-Trunk Group Assignment
4-41
LCR Class Selection
1-8-08
Class of Service (Station) Feature Selection 2
1-14-00 ACR Feature Allow/Deny Selection
1-14-01
ACR Dialling Assignment
1-14-01
ACR Dialled Number Dial Allow/Deny Selection
1-14-02
ACR Route Table Number Assignment
1-14-05 ACR Digit Add Assignment
1-14-03
ACR Trunk Group to Route Number Assignment
N
The maximum number of digits that can be deleted cannot exceed the number of digits used to route the call.
ACR Digit Delete Assignment
Route Setting
Title No. Data
0 1 = 0 0
D I S P L A Y
E to access the Memory Block.
I
~ to select Route No (01~32). and number of digits (00~10).
Memory Block Name
May 2003
1-14-05
System Mode
1
Submode
14
Data No.
05
PC Programming
a
+AO
1 - 251