Table 1-2 Multiline Terminal Keys Used For Programming - NEC Xen Master Programming Manual

NEC Business Solutions Ltd
1 - 6
Table 1-2 Multiline Terminal Keys Used for Programming provides a list and
description of the keys used during Multiline Terminal Programming.

Table 1-2 Multiline Terminal Keys Used for Programming

Key
Used to enter data from the dial pad and to specify a Memory Block
~
K I
location.
Used to move the cursor to the left. The cursor moves one character
J
space to the left each time
Used to move the cursor to the right. The cursor moves one character
L
space to the right each time
Used to select another mode. Press
O
• Mode or submode selection: Returns to Program Mode.
• Data No. Mode: Return to a mode or submode selection, or Program
Mode (if no submode exists).
Each time the conference key is pressed, Memory Block item changes
are as follows:
R • Tenant Mode: The tenant number increments by one.
• CO/PBX Line Mode: The CO/PBX line number increments by one.
• Telephone Mode: The telephone port number increments by one.
• Trunk Group Mode: The Trunk group number increments by one.
Y
Future use.
T
Used to return to the previous page in system programming.
X
Future use.
U
Used to enter a pause in speed dial programming mode or to clear data
in system programming mode.
Flexible Line keys are used to specify a mode or submode when
W
selecting a Memory Block or to select programming data for input.
S
Used to proceed to the next page in system programming.
This key is used to enter a pause, hyphen , asterisk and pound. To enter
an asterisk or pound:
Q
+
Q
S
+
The Message Waiting LED turns on and off after
pressed.
P
Used to exit the programming mode (go back on-line).
N
Used to write (save) data. After entering data press
written into memory. The next Memory Block is displayed.
Description
is pressed.
J
is pressed.
L
=
J
L =
#
Xen Master & Xen Axis
O
to switch modes as follows:
J and L are
N
, the data is
Multiline Terminal Programming