Dial Pad / Button Kit Replacement; Dial Pads/Button Kits; Dial Pad Installation; Programming The Digital Terminal For The Dial Pad - NEC UX5000 Hardware Manual

S 4-3
ECTION

DIAL PAD / BUTTON KIT REPLACEMENT

4.3.1

Dial Pads/Button Kits

With the UX5000 digital keysets (Enhanced terminals only) or IP terminals (IP-CTS or Enhanced terminals
only), replacement dial pads are available which can enhance the operations of the terminal for a specific use
(such as Hotel/Motel, ACD, retirement facility).
The current available replacement dial pad is for the Retro look (with Volume Up and Down keys and no
Navigation pad). A label for Braile usage is available as well. A replacement dial pad is also used iwith the PSA
Adapter (refer to Section 4-14 POWER FAILURE TERMINALS on page 4-53 for details on installing this dial
pad.) Other versions will be available in the near future.
The following installation instructions can be used for Value 2-Button or 6-Button, Enhanced 12-Button or
24-Button, or DESI-Less terminals. As the Value 2-Button and 6-Button currently have their version of the
Retro dial pad installed, there is no replacement required.
4.3.2

Dial Pad Installation

1. Remove any cable from the terminal (line cord, LAN cable, AC power).
2. Remove the existing dial button kit by prying up the lower plastic panel covering the dial pad. Also
remove the designation sheet used for labelling the terminal.
3. In the upper left-hand corner of the existing dial button kit, press the locking tab in towards the dial pad
keys while lifting off the dial button kit.
4. Insert the tabs of the new dial button kit located at the base of the dial button kit into the notches on the
terminal.
5. Push the upper portion of the dial button kit down until it clicks into position.
6. Press the buttons one by one to make sure that they are not stuck or that they have too much play.
7. Reattach the designation sheet and the upper and lower panels to the terminal.
4.3.3

Programming the Digital Terminal for the Dial Pad

1. With the terminal not plugged in and the handset on-hook, press the "4" and "6" buttons on the dial pad
and connect the terminal cables.
● This places the terminal into Service Class R/W mode. The MW LED should be lit.
2. Press "2" to enter the Button Kit mode.
● The MW LED should flash.
Chapter 4
Chapter 4 - Terminals and Optional Equipment
4 - 9