Procedure - Nortel Communication Server 100 Manual

176 Carrier Remote IPE maintenance
3
Checking the carrier performance status
The Remote Carrier Interface card can display carrier performance
information for the current hour and for the last 24 hours. The data and
total errors are shown separately in the report for both the local and the
remote site. The report displays the bit error rate, loss of frame count, loss
of signal, alarm indication count, and frame slip count.
To obtain the information for the current hour, execute command D P
(Display Performance) for near-end or D P D (Display Performance Distant)
for the far-end carrier performance status using the MMI terminal.
To obtain the carrier link performance status, follow the steps in
43 "Checking the carrier performance status" (page

Procedure 43

Checking the carrier performance status
Step
1
2
CRI::> D P
Which Carrier (0, 1, or 2): 1
Data for the first 45 Minutes
Display the alarm log by executing the D A and the D A D
commands to see the list of the most recent 100 alarms with the
date and time they occurred.
Action
Log in on the maintenance terminal as described in
system maintenance programs" (page
At the > prompt, type D P and press the Enter key.
The report displays the following carrier error counts monitored
for 45 minutes for carrier 1
IPE Interface Performance Log
For Carrier Number 1
8/15/95
Nortel Communication Server 1000
Carrier Remote IPE Fundamentals
NN43021-555 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
--End--
176).
154).
9:45
Procedure
"Using