Pre-Installation Preparation; Preparing The Site - Nortel Communication Server 100 Manual

56 Equipment installation and configuration
•
connecting the Local Carrier Interface maintenance cables in a
daisy-chain for multiple Local Carrier Interface cards
•
connecting the carrier link to the I/O panel assembly
Remote site installation procedures include:
•
installing the Carrier Remote IPE column or cabinet
•
installing the Remote Carrier Interface card into the Remote IPE
module or cabinet controller card slot
•
installing cables between the backplane connectors behind the Remote
Carrier Interface card and the I/O panel assembly at the rear of the
module or the bottom of the Carrier Remote IPE cabinet
•
connecting the slave system monitor and MMI terminal cables at the
Carrier Remote IPE site
•
connecting the carrier link to the Carrier Remote IPE

Pre-installation preparation

Pre-installation preparation consists of the following:
•

preparing the site

•
unpacking and inspection
•
taking inventory
•
selecting the network slot for the Local Carrier Interface card
•
installing the card, selecting the T1 or E1 carrier link
•
preparing the remote site cables, grounding, power source, and the
space for the Remote IPE column or cabinets
Preparing the site
When preparing a site, consider environmental, structural, and electrical
factors. These factors must be considered for the entire system; that
is, local and Carrier Remote IPE sites. This information is available in
Communication Server 1000M and Meridian 1 Large System Planning and
Engineering (NN43021-220) ().
To prepare the site for Carrier Remote IPE installation:
•
Install and verify the operation of the local system, without linking
to the Carrier Remote IPE sites. Refer to Communication Server
Nortel Communication Server 1000
Carrier Remote IPE Fundamentals
NN43021-555 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.