Nortel Communication Server 100 Manual page 137

IPE main and expansion cabinets, establish calls from stations connected
to the subscriber loops in the main and the expansion cabinets to verify
the intercabinet cable connection.
To perform a call hold/call retrieve test, follow the steps in
"Performing a call hold/call retrieve test" (page
Procedure 32
Performing a call hold/call retrieve test
Step Action
1 From a telephone at the local system site, dial a telephone at the
Carrier Remote IPE site and establish an active call connection.
2 Verify that voice transmission is established by talking with the
person at the other telephone.
3 Press the Hold key at the remote site to place the active call on
hold.
Note: To find out how to use the feature keys on different
telephones, consult the user manual that is supplied with the
telephone.
4 Place an outgoing call from the telephone at the remote site by
dialing an idle telephone located at the local system site.
5 Complete this outgoing call by first checking the voice clarity in
both directions and then hang up.
6 Have another telephone call you while the first call is still on hold.
7 Answer the incoming call and place it on hold.
8 Retrieve the call first held.
9 Complete the call and hang up.
10 Retrieve the second call on hold.
11 Complete the call and hang up.
12 Repeat this test for telephones connected to different subscriber
loops on the same card and different subscriber loops on
different line cards in the Carrier Remote IPE module or cabinet.
Making these calls generates traffic, which will be shown in the
traffic report.
Nortel Communication Server 1000
Carrier Remote IPE Fundamentals
NN43021-555 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
Performing acceptance testing 137
Procedure 32
137).
--End--