Nortel Communication Server 100 Manual page 71

Procedure 4
Installing the NT7R57AA Carrier and the NT7R58AA Maintenance Panel
assemblies
Step Action
1 Remove the back panel at the rear of the module to access the
I/O panel connector slots and later to route the NT7R67HA cable
P1 connector to the front of the module.
2 Identify a pair of empty connector cutouts that are the
appropriate size for the panel assemblies mounting holes.
These cutouts must be vertically or horizontally adjacent on the
same I/O panel.
3 From the rear of the module, route the DB-25 female P1
connector of the NT7R67BA cable assembly through the
module's cable channel to the front of the module.
Ensure that the cable connectors with attached panel assemblies
remain at the rear of the module next to the module's I/O panel
connector cutouts.
4 Install the NT7R57AA Carrier Panel assembly already connected
to the P3 DB-15 HD female connector of the NT7R67BA cable
assembly.
Mount it into the selected I/O panel connector cutout so that the
8-pin modular jack tabs are to the left.
Refer to Figure 11 "System monitor, local MMI terminal,
and carrier links cable connections" (page 73)
orientation.
Fasten the panel to the cutout by using the screw at the top of
the cutout.
5 Install the NT7R58AA Maintenance Panel assembly already
connected to the P2 DB-15 HD male connector of the
NT7R67BA cable assembly.
Mount it into the selected I/O panel connector cutout by using the
screw at the top of the cutout.
6 Plug the DB-25 male P1 connector of the NT7R67BA cable
assembly into the DB-25 female connector located on the
faceplate of the NT7R51 Local Carrier Interface card.
Nortel Communication Server 1000
Carrier Remote IPE Fundamentals
NN43021-555 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
Local equipment installation 71
for connector
--End--