Nortel Communication Server 100 Manual page 57

1000M and Meridian 1 Large System Installation and Commissioning
(NN43021-310) ().
•
Install the Carrier Remote IPE column. Refer to Communication Server
1000M and Meridian 1 Large System Installation and Commissioning
(NN43021-310) ()
or
•
Install the cabinet version of Carrier Remote IPE as described in
"Installing the Carrier Remote IPE cabinet" (page
Unpacking and inspection
Unpack and inspect the equipment for damage. When unpacking, follow
general precautions recommended by computer and telephone equipment
manufacturers:
•
Remove items that generate static charge from the installation site.
•
Use antistatic spray if the site is carpeted.
•
Wear an anti-static wrist strap and use an antistatic mat before
handling any equipment.
•
Remove equipment carefully from its packaging.
•
Visually inspect the equipment for obvious faults or damage. Report
any damaged component to the sales representative and the carrier
who delivered the equipment.
•
Hold the plug-in cards by their nonconductor edges and keep them in
their antistatic bags until ready to install them.
•
Do not stack the plug-in cards on top of each other.
Taking inventory
After the equipment has been unpacked and visually inspected, verify that
all the equipment is at the site before the installation begins. Equipment
received must be checked against the shipping documents. Any shortages
must be noted and reported to the sales representative.
Refer to Table 2 "Local site carrier hardware list" (page
"Remote Carrier IPE module hardware list" (page
"Carrier Remote IPE wall-mounted cabinet hardware list" (page 16)
"Carrier Remote IPE product description" (page 11)
description.
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
Nortel Communication Server 1000
Carrier Remote IPE Fundamentals
NN43021-555 04.01 4 June 2010
Pre-installation preparation 57
99).
13), Table 3
14), and Table 4
for carrier equipment
in the