Nortel Communication Server 100 Manual page 88

88 Equipment installation and configuration
•
Re-connect the system monitor daisy-chain to include new
Local Carrier Interface cards.
•
Test the system monitor daisy-chain by executing the STAT
XSM command in LD 37 to ensure that every local and remote
system monitor or Remote Carrier Interface card system
monitor emulation in the remote cabinet is responding to the
master system monitor.
Table 12 "Remote Carrier Interface standard (default) switch
settings" (page 88)
settings) for the Remote Carrier Interface card. These settings
are used in the majority of applications; however, if different
settings are required, change the switch settings before installing
the Remote Carrier Interface card.
Table 12
Remote Carrier Interface standard (default) switch settings
Switch 1
SW1 OFF
SW11 OFF
SW2 OFF
SW3 ON
SW4 ON
SW5 OFF
SW6 ON
SW7 ON
SW8 OFF
SW9 ON
SW10 ON
Figure 14 "Remote Carrier Interface card DIP-switch locations
and functions" (page 89)
Interface card DIP switches. SW2 through SW10 select the
carrier characteristic. SW1 and SW11 define repeater distance,
baud rate, and system monitor address.
Nortel Communication Server 1000
Carrier Remote IPE Fundamentals
NN43021-555 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
lists the default (factory-provided switch
Switch positions
2 3 4
ON ON OFF OFF
OFF OFF OFF ON
ON OFF ON
OFF ON ON
ON OFF OFF
ON OFF ON
OFF ON ON
ON OFF OFF
ON OFF ON
OFF ON ON
ON OFF OFF
shows the NT7R52AA Remote Carrier
5 6 7 8
OFF OFF OFF
OFF OFF OFF
- - - -
- - - -
- - - -
- - - -
- - - -
- - - -
- - - -
- - - -
- - - -