Nortel Communication Server 100 Manual page 121

Configuring the Carrier Remote IPE 121
To exit the MMI mode and return to the INIT mode, enter Q at the terminal
or TTY.
shows modes that a terminal or a TTY can be in and paths taken to
transition from one mode to the next. The three modes are Initial, MMI,
and SDI. The words in quotation marks shown along the paths must be
entered on the terminal to go from one mode to the next.
Figure 21
TTY or terminal modes at the local and the remote sites
Host SDI mode
In the Host SDI mode, a terminal is connected to the MMI port at the
Carrier Remote IPE. This terminal becomes the local maintenance and
service change TTY. At the local site, the Local Carrier Interface card
connects to the MMI port and to an SDI port of an SDI card.
Nortel Communication Server 1000
Carrier Remote IPE Fundamentals
NN43021-555 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.