Step Action - Nortel Communication Server 100 Manual

178 Carrier Remote IPE maintenance
11:00 1
10:00 0
Disabling a carrier when idle
Follow the steps in
the carrier sparing function or to perform off-line carrier tests" (page
178)
or to perform off-line carrier tests.
Procedure 44
Disabling a carrier when idle to check the carrier sparing function or to
perform off-line carrier tests
Step
1
2
1
0
Note: This report lists the 24-hour performance history for this
carrier. Ideally all the parameters should show 0 for optimum
performance. However, if the carrier is not in alarm state, it
can continue to perform within the specified threshold limits.
Procedure 44 "Disabling a carrier when idle to check
to disable a carrier when idle to check the carrier sparing function
Action
Execute the S C command to disable the desired primary carrier.
This command allows the calls in progress to complete before
the carrier can be disabled. The MMI terminal displays the
following screen to enable a change in carrier status:
To disable carrier 1 (set Equipped carrier 1 parameter
to N):
CRI::> S C
Equipped carrier 0 (Yes or No) Y
Equipped carrier 1 (Yes or No) N
Equipped carrier 2 (Yes or No) Y
Enable #2 for Spare (Yes or No) Y
Enable self clearing Alarms (Yes or
No) N
Track the number of calls still active on carrier 1 by executing
the STAT command:
LD 32
NPR000
STAT sl
Nortel Communication Server 1000
Carrier Remote IPE Fundamentals
NN43021-555 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
1 1
0 0
--End--
To set carrier parameters
Enable carrier 0. Enter Y to
enable or N to disable.
Disable carrier 1.
To enable carrier 2
Defines carrier 2 as spare
To enable/disable alarm
clearing
1 1
0 0