Nortel Communication Server 100 Manual page 154

154 Carrier Remote IPE maintenance
Table 27
MMI commands (cont'd.)
Command Description
Q Quit. Logs the terminal user out.
S A Set alarms. Set carrier alarm threshold and duration parameters.
Sets carrier configuration such as equipped/unequipped, automatic clearing of
S C
LED alarm indications, and carrier sparing.
S D Set date. Set date or verify current date.
S T Set time. Set time or verify current time.
@@@ Terminate the terminal connection.
T Test. Specifies a test from 1 to 5 to be run on the specified carrier link.
T D Test distant. A test from 1 through 5 conducted from the far-end.
Using system maintenance programs
To use system maintenance programs, access the system using a
maintenance terminal or maintenance telephone.
Logging in on the maintenance terminal
To access the program, enter a valid password. To do this, type LOGI and
press the Enter key. The following appears:
PASS?
Type the password and press the Enter key. Cursor will move without
showing characters while typing. If the following is displayed:
OVL015
>
an invalid password was entered. Type the password again and press the
Enter key. If a valid password was entered, the following is displayed:
>
Log-in has been achieved. Communication with the system is established
and the program can be accessed.
Accessing the program
To access any program on the system, type LD followed by a space and
the program number after the > prompt and press the Enter key.
For example, to access Network and IPE Diagnostic Program LD 32, type
LD 32 after the > prompt and press the Enter key. At the prompt, type the
command to execute.
Nortel Communication Server 1000
Carrier Remote IPE Fundamentals
NN43021-555 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.